Certificate/Reg.-No. | 968/FSP 1205.02/21 |
Type of Certificate | A-FS&CS Certificate |
Certificate Holder | Dynisco |
Manufacturer | Dynisco |
Product Category | Sensors, Transmitters, Guards > for Pressure |
Subject | Pressure Transmitter and Transducer |
Type Designation | SPX 2xxx-..., SPX 3xxx-... (with linearity correction and process temperature compensation) (SPX-T 3xxx), SPX 4xxx-..., SPX 5xxx-... (with linearity correction) (SPX-L 5xxx), each optionally with separate monitoring channel for over-pressure (Guardian series, option code at the end of the model code: GCxxx) |
Codes and Standards |
|
Scope and Result | Pressure measurement and monitoring, 4 - 20 mA output proportional to the pressure. The transmitters meet the requirements up to SIL 2 (low demand mode of operation) in HFT=0 architecture and SIL 2 (any mode of operation) in HFT=1 architecture acc. to IEC 61508 and IEC 61511-1 (Route 2), and may be used accordingly. They further meet in a HFT=0 architecture SIL 1 and in HFT=1 SIL 2 requirements of EN 62061. The monitoring channel in the Guardian Series Transducers meets Cat. 1 / PL c acc. to ISO 13849-1 and may be used accordingly in safety functions up to PL c and SIL 1 acc. to EN 62061/IEC 61508/IEC 61511-1. If 2 monitoring channels are used (HFT = 1 architecture), they may be used in safety functions up to PL d and SIL 2. |
Specific Provisions | The instructions of the associated Operating Manual and the Datasheets shall be considered. Further information see page 2 of this certificate. |
Valid Until | no expiry date |
Appendixes | n/a |
Download Certificate | 968_FSP_1205_02_21_en_el.pdf |
Certificate/Reg.-No. | Certificate Holder | Product Category | Product Tested | Type Designation | Details |
---|
968/FSP 1205.02/21 | Dynisco | Sensors, Transmitters, Guards → for Pressure | Pressure Transmitter and Transducer | SPX 2xxx-..., SPX 3xxx-... (with linearity correction and process temperature compensation) (SPX-T 3xxx), SPX 4xxx-..., SPX 5xxx-... (with linearity correction) (SPX-L 5xxx), each optionally with separate monitoring channel for over-pressure (Guardian series, option code at the end of the model code: GCxxx) | View Details | View PDF |
Remark: In case of missing entries this is due to restrictions by the certificate holder